3/24/2021 0 Comments Install Clover Bootloader
On the 3rd page of the installer make sure to select your USB as the destination.
Clover Bootloader Series Board WillPage of the Clover Installer - Note the Customize button in the bottom left The usual options you want to check in the Customize menu are shown in the following screenshots with an explanation of each after ( Note: any non-Z370 300-series board will need EmuVariableUefi-64 as well - it is located under UEFI Drivers - Additional drivers in current Clover packages): Recommended Customization Settings Install Clover for UEFI booting only Install Clover to the ESP Under UEFI Drivers: AptioMemoryFix (the new hotness that includes NVRAM fixes, as well as better memory management) Note: You can use OsxAptioFix3Drv located in UEFI Drivers - Memory fix drivers if using the official Clover installer from SourceForge.Optionally, you can download the final release of AptioMemoryFix from here HFSPlus (or VBoxHfs ) - one of these is required for Clover to see and boot HFS volumes.If you see the option to enable it in the installer, make sure its selected - if you dont see it in the installer, verify that one of them exists in your Clover installs efi drivers folder ApfsDriverLoader - (Available in Dids Clover builds - or here ) this allows Clover to see and boot from APFS volumes by loading apfs.efi from the ApfsContainer located on block device (if using AptioMemoryFix as well, ensure you have R21 or newer) Thats it. If you dont need FileVault, and are setting up a standard UEFI installation, these are the only entries you should need. Clover Bootloader Free To DeselectYou may find more than the above selected in the UEFI Drivers section and subsections - feel free to deselect any not listed. There are some that can even cause conflicts with other settingskexts (Like SMCHelper-64.efi ), so its a good idea to run as lean as possible here. Where do they install If you need to manually make changes to the efi drivers on your Clover installation (or just verify that you have what you need), their location may differ depending on your Clover version. Clover version up to r4982: EFI - CLOVER - drivers64UEFI Clover versions r4983 to r4985: EFI - CLOVER - UEFIDrivers Will still use EFI - CLOVER - drivers64UEFI if the above is not found Clover versions r4986 to present: EFI - CLOVER - drivers - UEFI Will still use EFI - CLOVER - drivers64UEFI if the above is not found Copying Kexts Once Clover has been installed, youll see the EFI partition of your USB on the desktop - we want to navigate to EFI - CLOVER - kexts - Other and copy the kexts we downloaded earlier there. Any dSYM files can be ignored, we only want the.kext files. But what about the 10.xx folders When Clover is looking to inject kexts, the kexts in the 10.xx folders are only injected if Clover determines that the folder name matches the booted OS version. There are very few kexts that are OS version-dependent though, and updating the OS while forgetting to migrate the kexts can leave you in an unbootable state. The kexts located in the Other folder will inject regardless of the detected OS version. Previous Building the USB Installer Next Config.plist Basics Last updated 1 year ago Edit on GitHub Contents Installing Clover Copying Kexts.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |